The Ultimate in Servo Mounts

To contact us:

David Ingoldby

Phone: +44(0) 7754901324

E-mail: dingoservo@gmail.com

www.dingoservo.co.uk

A 2  and 4 channel DCC Accessory Decoders

This Control Board is designed to operate one of our Twin Control Boards from DCC.

It is only 33 x 33 mm in size and interfaces with the Twin boards by means of 3 pins.

It is very easy to set up and operate.

Full description of its operating and setup procedure on the pdf file on the "Downloads" page.

The new 4 Channel DCC accessory decoder will interface directly with our Multi Control Boards

This means that you can operate both points and signals from one control board

As the 2 channel board, this is very easy to setup and operate

All boards are completely isolated from the DCC signal by means of optocouplers on the outputs.

NOTE: This board has now been upgraded to draw its power from the multiboard  +12VDC

This means that if the DCC fails or shorts out the board will continue to hold its information and won't change your points etc.

Once the DCC is restored it will work as normal.

Grateful thanks to Julien Coles for help with the firmware on both of these boards..