The Ultimate in Servo Mounts
To contact us:
David Ingoldby
Phone: +44(0) 7754901324
E-mail: dingoservo@gmail.com
www.dingoservo.co.uk
Single DCC controlled servo Board
Downloads
Product List
Contact Us
Video Links
Price List and
Order info.
This is a single DCC Servo Decoder for points.
1 The key new feature of this decoder is that the servo end positions are set using the DCC controller which operates the layout - no setting box is needed. Any DCC Controller can be used even if it is a ‘Toggling’ controller (eg NCE or Digitrax) which doesn’t send continuous DCC commands (eg Multimaus/Z21).
2 Frog switching is included - just run a wire up to the frog. Switching is solid-state (opto- MOSFETs). Current is 2A continuous, 6A peak. No microswitches needed
3 Powered by the DCC bus
4 Servo direction can be set.
5 Servo speed is adjusted with a potentiometer on the PCB.
These instructions assume that your DCC Controller sends accessory/point control commands for either ‘Straight’, or ‘Turned’.
In the case of NCE a double tap changes direction.